Description
M4 brass tapered nut for use with a Quick-set hot end.
Quick-set tapered nut
£2.50
Out of stock
Only logged in customers who have purchased this product may leave a review.
Related Products
Cartridge heater
Cartridge heater, available for use at 19v (yellow leads) or 12v (red leads). Length: 15mm Diameter: 5mm Wire length: 160mm Please note: the 19v cartridge heaters are now supplied with yellow leads and replace the heaters with white leads, to … Read More
One piece nozzle
One piece stainless steel nozzle to fit RepRapPro Ormerod, Huxley or Mendel hot end. The nozzle comes with a short length of PTFE liner. This is pre-fitted before shipping. Please select 0.3mm or 0.5mm nozzle size from the drop down.
Axial fan 50mm
50mm Axial (blower) fan. Runs at 19v. Suitable for Fisher and Huxley 3D printers.
Hobbed insert
Stainless steel hobbed insert, drives the filament into the hot end of your 3D printer. Also fit RepRapPro extruder drives.
Meanwell 12v PSU
As used on the RepRapPro Ormerod 2 3D printer. This power supply features auto input voltage switching for AC 110v or 240v operation, and is extremely robust. It will happily power a 200x200mm (8″x8″) heated bed, as well as NEMA17 … Read More
Heatsink block
Aluminium heatsink block for RepRapPro hot end. Suitable for use with Ormerod, Huxley and Mendel kits. Please note – this part is not suitable for use with the Quick-set hot end.
Proximity sensor
The modulated proximity sensor and loom consists of an infra-red emitter and detector and the four wire loom to connect it to the controller PCB. The proximity sensor is attached to the X carriage and it works by bouncing infra-red light off … Read More
Reviews
There are no reviews yet.