04-nozzle-3
0.4mm nozzle

Fisher 0.4mm diameter stainless steel nozzle.

not rated 7.06Add to basket
12v240wpsu-1
12v 240W PSU

12v 240W 20A power supply Brand new in box, high quality power supply. AC input voltage selector switch, select either 110v or 240v. This PSU is meant for internal use. The buyer is responsible for ensuring safety of the installation.

not rated 17.54Add to basket
19v-120w-psu
19v 120W power supply

Fisher Delta 3D printer power supply, suitable for running a heated print surface. To upgrade your Fisher, please see our heatbed upgrade bundle here. Power supply specification: 19v, 6.32A, 120W, 5.5*2.5 connector.  

not rated 29.30Add to basket
fanHeatsink
40x40mm heatisnk

Heatsink to fit 40x40mm radial fans. Pre-drilled to fit RepRapPro heatsink blocks, including Quick-set.

not rated 3.77Add to basket
fan_12v
40x40x10mm fan

Select 19v for use in Fisher, the Huxley hot end, or as a part cooling fan for a Huxley 3D printer. Select 12v for use in the Mendel hot end, Ormerod hot end or as a part cooling fan for a Mendel or Ormerod 3D … Read More

not rated 2.35Select options
axial-fan-50mm
Axial fan 50mm

50mm Axial (blower) fan. Runs at 19v. Suitable for Fisher and Huxley 3D printers.

not rated 4.65Add to basket
thermistor_100k
Axial thermistor 100k

DO-35 style axial thermistor suitable for all RepRapPro hot ends. The thermistor comes with a length of PTFE heatshrink.

not rated 3.47Add to basket
bowden-end-1
Bowden end fitting

Brass fitting for hot end of bowden tube. Fits RepRapPro hot ends that use the one piece stainless nozzles.

not rated 3.30Add to basket
bowden_tube_start_small
Bowden start fitting

Brass fitting for 4mm diameter bowden tube, also suitable for RepRapPro hot ends.

not rated 3.41Add to basket
1262-BuildTak-Dia-165mm
Buildtak print surface

Ideal build surface for our Fisher 3D printers Key Features: Works with PLA, ABS, HIPS, PET+, Brick, Wood & Flexible (TPE) filaments; additionally we have had success with getting nylon and t-glase (PETT) to adhere when used with a thin layer … Read More

not rated 7.06Add to basket
cartridge-heater-19v
Cartridge heater

Cartridge heater, available for use at 19v (yellow leads) or 12v (red leads). Length: 15mm Diameter: 5mm Wire length: 160mm Please note: the 19v cartridge heaters are now supplied with yellow leads and replace the heaters with white leads, to … Read More

not rated 5.88Select options
duet_big
Duet PCB

The Duet is an open-source 3D printer controller board, which offers a range of improvements over traditional 8-bit AVR based control boards. Features Hardware: 32 bit ARM microprocessor as found on the Arduino Due, running at up to 84MHz 12-35v … Read More

5 out of 5
87.09Add to basket