Proximity sensor
The modulated proximity sensor and loom consists of an infra-red emitter and detector and the four wire loom to connect it to the controller PCB. The proximity sensor is attached to the X carriage and it works by bouncing infra-red light off … Read More
PTFE bowden tube
PTFE bowden tube 4mm OD x 450mm length for use with RepRapPro 3D printers. This is the tube which leads from the extruder drive to the hot end along which the filament is fed.
Quick-set cooling block
Aluminium heatsink cooling block for use in a RepRapPro Quick-set hot end. Suitable for use with Huxley Duo, Mendel 3, the Dual Colour Upgrade kits kits and Ormerod 2 kits. Nozzle changes with the Quick-set cooling block are easy – simply … Read More
Quick-set heater block
Heater block for Fisher hot end. The Quick-set heater block is also used in RepRapPro Quick-set hot ends as used in Huxley Duo, Mendel 3 and the Dual Colour Upgrade kits and Ormerod 2 kits shipped from June 2015.
Quickset nozzle
The Quick-set Nozzle is designed to be used in Quick-set hot ends, as used in Huxley Duo, Mendel 3, the Dual Colour Upgrade kits and Ormerod 2 kits shipped from June 2015. The nozzle is made from stainless steel and there … Read More
