Description
Set of 3 Fisher Delta bed springs.
Fisher bed springs
£1.80
Out of stock
Additional information
| Pack qty | 3 |
|---|
Only logged in customers who have purchased this product may leave a review.
Related Products
Duet Shield PCB
The Duet Shield PCB adds the capability of driving up to two more extruders for three feed machines. The board has been designed to neatly fit over the Duet and it has horizontal connectors to give it a low profile … Read More
40x40x10mm fan
Select 19v for use in Fisher, the Huxley hot end, or as a part cooling fan for a Huxley 3D printer. Select 12v for use in the Mendel hot end, Ormerod hot end or as a part cooling fan for a Mendel or Ormerod 3D … Read More
MXL Pulley
Aluminium drive pulley. 18 teeth. MXL tooth profile, 2.032mm pitch, to fit MXL belt which you can get from here. The pulleys are supplied with an M3 grub screw.
PTFE bowden tube
PTFE bowden tube 4mm OD x 450mm length for use with RepRapPro 3D printers. This is the tube which leads from the extruder drive to the hot end along which the filament is fed.
Proximity sensor
The modulated proximity sensor and loom consists of an infra-red emitter and detector and the four wire loom to connect it to the controller PCB. The proximity sensor is attached to the X carriage and it works by bouncing infra-red light off … Read More
Hobbed insert
Stainless steel hobbed insert, drives the filament into the hot end of your 3D printer. Also fit RepRapPro extruder drives.
Cartridge heater
Cartridge heater, available for use at 19v (yellow leads) or 12v (red leads). Length: 15mm Diameter: 5mm Wire length: 160mm Please note: the 19v cartridge heaters are now supplied with yellow leads and replace the heaters with white leads, to … Read More
Bowden end fitting
Brass fitting for hot end of bowden tube. Fits RepRapPro hot ends that use the one piece stainless nozzles.
Reviews
There are no reviews yet.