Aluminium heatsink cooling block for use in a RepRapPro Quick-set hot end. Suitable for use with Huxley Duo, Mendel 3, the Dual Colour Upgrade kits kits and Ormerod 2 kits. Nozzle changes with the Quick-set cooling block are easy – simply … Read More
The Duet is an open-source 3D printer controller board, which offers a range of improvements over traditional 8-bit AVR based control boards. Features Hardware: 32 bit ARM microprocessor as found on the Arduino Due, running at up to 84MHz 12-35v … Read More
One piece stainless steel nozzle to fit RepRapPro Ormerod, Huxley or Mendel hot end. The nozzle comes with a short length of PTFE liner. This is pre-fitted before shipping. Please select 0.3mm or 0.5mm nozzle size from the drop down.
Heater block for Fisher hot end. The Quick-set heater block is also used in RepRapPro Quick-set hot ends as used in Huxley Duo, Mendel 3 and the Dual Colour Upgrade kits and Ormerod 2 kits shipped from June 2015.
The modulated proximity sensor and loom consists of an infra-red emitter and detector and the four wire loom to connect it to the controller PCB. The proximity sensor is attached to the X carriage and it works by bouncing infra-red light off … Read More