Description
Fisher M4 brass tapered nut
M4 tapered nut
£2.50
Out of stock
Only logged in customers who have purchased this product may leave a review.
Related Products
Duet Shield PCB
The Duet Shield PCB adds the capability of driving up to two more extruders for three feed machines. The board has been designed to neatly fit over the Duet and it has horizontal connectors to give it a low profile … Read More
PTFE bowden tube
PTFE bowden tube 4mm OD x 450mm length for use with RepRapPro 3D printers. This is the tube which leads from the extruder drive to the hot end along which the filament is fed.
Bowden end fitting
Brass fitting for hot end of bowden tube. Fits RepRapPro hot ends that use the one piece stainless nozzles.
Quick-set heater block
Heater block for Fisher hot end. The Quick-set heater block is also used in RepRapPro Quick-set hot ends as used in Huxley Duo, Mendel 3 and the Dual Colour Upgrade kits and Ormerod 2 kits shipped from June 2015.
Proximity sensor
The modulated proximity sensor and loom consists of an infra-red emitter and detector and the four wire loom to connect it to the controller PCB. The proximity sensor is attached to the X carriage and it works by bouncing infra-red light off … Read More
NEMA17 stepper motor
NEMA 17 stepper motor, fits Fisher 3D printer. Also suitable for Ormerod and Mendel sized 3D printers and geared extruder drives. Frame size: 42mm Length: 34mm Shaft diameter: 5mm
Reviews
There are no reviews yet.