One piece stainless steel nozzle to fit RepRapPro Ormerod, Huxley or Mendel hot end. The nozzle comes with a short length of PTFE liner. This is pre-fitted before shipping. Please select 0.3mm or 0.5mm nozzle size from the drop down.
Cartridge heater, available for use at 19v (yellow leads) or 12v (red leads). Length: 15mm Diameter: 5mm Wire length: 160mm Please note: the 19v cartridge heaters are now supplied with yellow leads and replace the heaters with white leads, to … Read More
Fisher Delta 3D printer power supply, suitable for running a heated print surface. To upgrade your Fisher, please see our heatbed upgrade bundle here. Power supply specification: 19v, 6.32A, 120W, 5.5*2.5 connector.
The modulated proximity sensor and loom consists of an infra-red emitter and detector and the four wire loom to connect it to the controller PCB. The proximity sensor is attached to the X carriage and it works by bouncing infra-red light off … Read More
The Quick-set Nozzle is designed to be used in Quick-set hot ends, as used in Huxley Duo, Mendel 3, the Dual Colour Upgrade kits and Ormerod 2 kits shipped from June 2015. The nozzle is made from stainless steel and there … Read More