Description
M4 brass tapered nut for use with a Quick-set hot end.
Quick-set tapered nut
$3.32
Out of stock
Only logged in customers who have purchased this product may leave a review.
Related Products
Duet Shield PCB
The Duet Shield PCB adds the capability of driving up to two more extruders for three feed machines. The board has been designed to neatly fit over the Duet and it has horizontal connectors to give it a low profile … Read More
PTFE bowden tube
PTFE bowden tube 4mm OD x 450mm length for use with RepRapPro 3D printers. This is the tube which leads from the extruder drive to the hot end along which the filament is fed.
40x40mm heatisnk
Heatsink to fit 40x40mm radial fans. Pre-drilled to fit RepRapPro heatsink blocks, including Quick-set.
Heatsink block
Aluminium heatsink block for RepRapPro hot end. Suitable for use with Ormerod, Huxley and Mendel kits. Please note – this part is not suitable for use with the Quick-set hot end.
Quick-set heater block
Heater block for Fisher hot end. The Quick-set heater block is also used in RepRapPro Quick-set hot ends as used in Huxley Duo, Mendel 3 and the Dual Colour Upgrade kits and Ormerod 2 kits shipped from June 2015.
Proximity sensor
The modulated proximity sensor and loom consists of an infra-red emitter and detector and the four wire loom to connect it to the controller PCB. The proximity sensor is attached to the X carriage and it works by bouncing infra-red light off … Read More
Reviews
There are no reviews yet.