Description
M4 brass tapered nut for use with a Quick-set hot end.
- You cannot add "12v 240W PSU" to the basket because the product is out of stock.
Quick-set tapered nut
$3.32
Out of stock
Only logged in customers who have purchased this product may leave a review.
Related Products
One piece nozzle
One piece stainless steel nozzle to fit RepRapPro Ormerod, Huxley or Mendel hot end. The nozzle comes with a short length of PTFE liner. This is pre-fitted before shipping. Please select 0.3mm or 0.5mm nozzle size from the drop down.
PTFE bowden tube
PTFE bowden tube 4mm OD x 450mm length for use with RepRapPro 3D printers. This is the tube which leads from the extruder drive to the hot end along which the filament is fed.
Proximity sensor
The modulated proximity sensor and loom consists of an infra-red emitter and detector and the four wire loom to connect it to the controller PCB. The proximity sensor is attached to the X carriage and it works by bouncing infra-red light off … Read More
Duet Shield PCB
The Duet Shield PCB adds the capability of driving up to two more extruders for three feed machines. The board has been designed to neatly fit over the Duet and it has horizontal connectors to give it a low profile … Read More
Endstop microswitch
Short lever microswitch for use with Fisher Delta 3D printer. This microswitch is also suitable for use as an endstop on Mendel, Ormerod and Huxley 3D printers.
19v 120W power supply
Fisher Delta 3D printer power supply, suitable for running a heated print surface. To upgrade your Fisher, please see our heatbed upgrade bundle here. Power supply specification: 19v, 6.32A, 120W, 5.5*2.5 connector.
Reviews
There are no reviews yet.