12v 240W PSU

12v 240W 20A power supply Brand new in box, high quality power supply. AC input voltage selector switch, select either 110v or 240v. This PSU is meant for internal use. The buyer is responsible for ensuring safety of the installation.

not rated 16.99 Read more
19v 120W power supply

Fisher Delta 3D printer power supply, suitable for running a heated print surface. To upgrade your Fisher, please see our heatbed upgrade bundle here. Power supply specification: 19v, 6.32A, 120W, 5.5*2.5 connector.  

not rated 34.22 Read more
40x40x10mm fan

Select 19v for use in Fisher, the Huxley hot end, or as a part cooling fan for a Huxley 3D printer. Select 12v for use in the Mendel hot end, Ormerod hot end or as a part cooling fan for a Mendel or Ormerod 3D … Read More

not rated 2.28 Select options This product has multiple variants. The options may be chosen on the product page
Axial fan 50mm

50mm Axial (blower) fan. Runs at 19v. Suitable for Fisher and Huxley 3D printers.

not rated 4.50 Add to basket
Axial thermistor 100k

DO-35 style axial thermistor suitable for all RepRapPro hot ends. The thermistor comes with a length of PTFE heatshrink.

not rated 3.36 Read more
Cartridge heater

Cartridge heater, available for use at 19v (yellow leads) or 12v (red leads). Length: 15mm Diameter: 5mm Wire length: 160mm Please note: the 19v cartridge heaters are now supplied with yellow leads and replace the heaters with white leads, to … Read More

not rated 5.70 Select options This product has multiple variants. The options may be chosen on the product page
Duet Shield PCB

The Duet Shield PCB adds the capability of driving up to two more extruders for three feed machines. The board has been designed to neatly fit over the Duet and it has horizontal connectors to give it a low profile … Read More

not rated 33.07 Add to basket
Endstop microswitch

Short lever microswitch for use with Fisher Delta 3D printer. This microswitch is also suitable for use as an endstop on Mendel, Ormerod and Huxley 3D printers.

not rated 1.14 Add to basket
Meanwell 12v PSU

As used on the RepRapPro Ormerod 2 3D printer. This power supply features auto input voltage switching for AC 110v or 240v operation, and is extremely robust. It will happily power a 200x200mm (8″x8″) heated bed, as well as NEMA17 … Read More

not rated 45.62 Read more
Motor loom

Wiring loom for stepper motor. Four wires, terminated with Molex servo style connector at one end, and standard JST stepper motor connector at the other end. Please select desired length form the drop down menu.  

not rated From: 1.71 Select options This product has multiple variants. The options may be chosen on the product page
NEMA17 stepper motor

NEMA 17 stepper motor, fits Fisher 3D printer. Also suitable for Ormerod and Mendel sized 3D printers and geared extruder drives. Frame size: 42mm Length: 34mm Shaft diameter: 5mm

not rated From: 12.43 Select options This product has multiple variants. The options may be chosen on the product page
Proximity sensor

The modulated proximity sensor and loom consists of an infra-red emitter and detector and the four wire loom to connect it to the controller PCB. The proximity sensor is attached to the X carriage and it works by bouncing infra-red light off … Read More

not rated From: 9.69 Select options This product has multiple variants. The options may be chosen on the product page