Description
Short lever microswitch for use with Fisher Delta 3D printer.
This microswitch is also suitable for use as an endstop on Mendel, Ormerod and Huxley 3D printers.
Endstop microswitch
£1.00
Only logged in customers who have purchased this product may leave a review.
Related Products
Proximity sensor
The modulated proximity sensor and loom consists of an infra-red emitter and detector and the four wire loom to connect it to the controller PCB. The proximity sensor is attached to the X carriage and it works by bouncing infra-red light off … Read More
Duet Shield PCB
The Duet Shield PCB adds the capability of driving up to two more extruders for three feed machines. The board has been designed to neatly fit over the Duet and it has horizontal connectors to give it a low profile … Read More
Bowden start fitting
Brass fitting for 4mm diameter bowden tube, also suitable for RepRapPro hot ends.
Cartridge heater
Cartridge heater, available for use at 19v (yellow leads) or 12v (red leads). Length: 15mm Diameter: 5mm Wire length: 160mm Please note: the 19v cartridge heaters are now supplied with yellow leads and replace the heaters with white leads, to … Read More
Quick-set heater block
Heater block for Fisher hot end. The Quick-set heater block is also used in RepRapPro Quick-set hot ends as used in Huxley Duo, Mendel 3 and the Dual Colour Upgrade kits and Ormerod 2 kits shipped from June 2015.
Heater block M5
Aluminium heater block for RepRapPro hot end. Suitable for use with Ormerod, Huxley and Mendel kits. Please note – this part is NOT suitable for use with our Quick-set Hot End and All Metal Nozzles as used in Huxley Duo, Mendel … Read More
Reviews
There are no reviews yet.