Description
Pack of 12.
Diameter 6mm, with an M3 thread, as used on the Fisher Delta 3D printer.
Threaded steel balls
£3.00
Pack of 12
Out of stock
Only logged in customers who have purchased this product may leave a review.
Related Products
Bowden start fitting
Brass fitting for 4mm diameter bowden tube, also suitable for RepRapPro hot ends.
Proximity sensor
The modulated proximity sensor and loom consists of an infra-red emitter and detector and the four wire loom to connect it to the controller PCB. The proximity sensor is attached to the X carriage and it works by bouncing infra-red light off … Read More
MXL drive belt
Black rubber, fibreglass reinforced, 1/4 ” (6.25mm) wide MXL drive belt. Works with MXL pulleys. Priced per metre.
Quick-set heater block
Heater block for Fisher hot end. The Quick-set heater block is also used in RepRapPro Quick-set hot ends as used in Huxley Duo, Mendel 3 and the Dual Colour Upgrade kits and Ormerod 2 kits shipped from June 2015.
Heatsink block
Aluminium heatsink block for RepRapPro hot end. Suitable for use with Ormerod, Huxley and Mendel kits. Please note – this part is not suitable for use with the Quick-set hot end.
One piece nozzle
One piece stainless steel nozzle to fit RepRapPro Ormerod, Huxley or Mendel hot end. The nozzle comes with a short length of PTFE liner. This is pre-fitted before shipping. Please select 0.3mm or 0.5mm nozzle size from the drop down.
12v 240W PSU
12v 240W 20A power supply Brand new in box, high quality power supply. AC input voltage selector switch, select either 110v or 240v. This PSU is meant for internal use. The buyer is responsible for ensuring safety of the installation.
Reviews
There are no reviews yet.