40x40mm heatisnk

Heatsink to fit 40x40mm radial fans. Pre-drilled to fit RepRapPro heatsink blocks, including Quick-set.

not rated 3.65 Add to basket
40x40x10mm fan

Select 19v for use in Fisher, the Huxley hot end, or as a part cooling fan for a Huxley 3D printer. Select 12v for use in the Mendel hot end, Ormerod hot end or as a part cooling fan for a Mendel or Ormerod 3D … Read More

not rated 2.28 Select options
Axial thermistor 100k

DO-35 style axial thermistor suitable for all RepRapPro hot ends. The thermistor comes with a length of PTFE heatshrink.

not rated 3.36 Read more
Duet Shield PCB

The Duet Shield PCB adds the capability of driving up to two more extruders for three feed machines. The board has been designed to neatly fit over the Duet and it has horizontal connectors to give it a low profile … Read More

not rated 33.07 Add to basket
Hobbed insert

Stainless steel hobbed insert, drives the filament into the hot end of your 3D printer. Also fit RepRapPro extruder drives.

not rated 5.70 Read more
Meanwell 12v PSU

As used on the RepRapPro Ormerod 2 3D printer. This power supply features auto input voltage switching for AC 110v or 240v operation, and is extremely robust. It will happily power a 200x200mm (8″x8″) heated bed, as well as NEMA17 … Read More

not rated 45.62 Read more
MXL drive belt

Black rubber, fibreglass reinforced, 1/4 ” (6.25mm) wide MXL drive belt. Works with MXL pulleys. Priced per metre.

not rated 4.56 Add to basket
MXL Pulley

Aluminium drive pulley. 18 teeth. MXL tooth profile, 2.032mm pitch, to fit MXL belt which you can get from here. The pulleys are supplied with an M3 grub screw.

not rated 2.45 Add to basket
NEMA17 stepper motor

NEMA 17 stepper motor, fits Fisher 3D printer. Also suitable for Ormerod and Mendel sized 3D printers and geared extruder drives. Frame size: 42mm Length: 34mm Shaft diameter: 5mm

not rated From: 12.43 Select options
Proximity sensor

The modulated proximity sensor and loom consists of an infra-red emitter and detector and the four wire loom to connect it to the controller PCB. The proximity sensor is attached to the X carriage and it works by bouncing infra-red light off … Read More

not rated From: 9.69 Select options
Quick-set cooling block

Aluminium heatsink cooling block for use in a RepRapPro Quick-set hot end. Suitable for use with Huxley Duo, Mendel 3, the Dual Colour Upgrade kits kits and Ormerod 2 kits. Nozzle changes with the Quick-set cooling block are easy – simply … Read More

not rated 9.12 Read more
Quickset nozzle

The Quick-set Nozzle is designed to be used in Quick-set hot ends, as used in Huxley Duo, Mendel 3, the Dual Colour Upgrade kits and Ormerod 2 kits shipped from June 2015. The nozzle is made from stainless steel and there … Read More

not rated 8.15 Select options