Description
Pack of 12.
Diameter 6mm, with an M3 thread, as used on the Fisher Delta 3D printer.
Threaded steel balls
$3.99
Pack of 12
Out of stock
Only logged in customers who have purchased this product may leave a review.
Related Products
Bowden start fitting
Brass fitting for 4mm diameter bowden tube, also suitable for RepRapPro hot ends.
Proximity sensor
The modulated proximity sensor and loom consists of an infra-red emitter and detector and the four wire loom to connect it to the controller PCB. The proximity sensor is attached to the X carriage and it works by bouncing infra-red light off … Read More
Axial fan 50mm
50mm Axial (blower) fan. Runs at 19v. Suitable for Fisher and Huxley 3D printers.
Quick-set heater block
Heater block for Fisher hot end. The Quick-set heater block is also used in RepRapPro Quick-set hot ends as used in Huxley Duo, Mendel 3 and the Dual Colour Upgrade kits and Ormerod 2 kits shipped from June 2015.
Quickset nozzle
The Quick-set Nozzle is designed to be used in Quick-set hot ends, as used in Huxley Duo, Mendel 3, the Dual Colour Upgrade kits and Ormerod 2 kits shipped from June 2015. The nozzle is made from stainless steel and there … Read More
40x40mm heatisnk
Heatsink to fit 40x40mm radial fans. Pre-drilled to fit RepRapPro heatsink blocks, including Quick-set.
40x40x10mm fan
Select 19v for use in Fisher, the Huxley hot end, or as a part cooling fan for a Huxley 3D printer. Select 12v for use in the Mendel hot end, Ormerod hot end or as a part cooling fan for a Mendel or Ormerod 3D … Read More
Reviews
There are no reviews yet.