Motor loom

Wiring loom for stepper motor. Four wires, terminated with Molex servo style connector at one end, and standard JST stepper motor connector at the other end. Please select desired length form the drop down menu.  

not rated From: £1.50 Select options
MXL drive belt

Black rubber, fibreglass reinforced, 1/4 ” (6.25mm) wide MXL drive belt. Works with MXL pulleys. Priced per metre.

not rated £4.00 Add to basket
MXL Pulley

Aluminium drive pulley. 18 teeth. MXL tooth profile, 2.032mm pitch, to fit MXL belt which you can get from here. The pulleys are supplied with an M3 grub screw.

not rated £2.15 Add to basket
NEMA17 stepper motor

NEMA 17 stepper motor, fits Fisher 3D printer. Also suitable for Ormerod and Mendel sized 3D printers and geared extruder drives. Frame size: 42mm Length: 34mm Shaft diameter: 5mm

not rated From: £10.90 Select options
One piece nozzle

One piece stainless steel nozzle to fit RepRapPro Ormerod, Huxley or Mendel hot end. The nozzle comes with a short length of PTFE liner. This is pre-fitted before shipping. Please select 0.3mm or 0.5mm nozzle size from the drop down.

not rated £5.00 Select options
Placeholder
PLA 0.5Kg

eSun PLA 0.5Kg spool.

not rated £6.00 Read more
Pneumatic fitting

Pneumatic fitting for Fisher Delta bowden (filament feed) tube. Inner diameter 4.2mm to suit 4mm diameter PTFE bowden tube. M6 thread to fit hot end heatsink and printed extruder drive block.

not rated £2.20 Add to basket
Proximity sensor

The modulated proximity sensor and loom consists of an infra-red emitter and detector and the four wire loom to connect it to the controller PCB. The proximity sensor is attached to the X carriage and it works by bouncing infra-red light off … Read More

not rated From: £8.50 Select options
PTFE bowden tube

PTFE bowden tube 4mm OD x 450mm length for use with RepRapPro 3D printers. This is the tube which leads from the extruder drive to the hot end along which the filament is fed.

not rated £2.50 Read more
Quick-set cooling block

Aluminium heatsink cooling block for use in a RepRapPro Quick-set hot end. Suitable for use with Huxley Duo, Mendel 3, the Dual Colour Upgrade kits kits and Ormerod 2 kits. Nozzle changes with the Quick-set cooling block are easy – simply … Read More

not rated £8.00 Read more
Quick-set heater block

Heater block for Fisher hot end. The Quick-set heater block is also used in RepRapPro Quick-set hot ends as used in Huxley Duo, Mendel 3 and the Dual Colour Upgrade kits and Ormerod 2 kits shipped from June 2015.

not rated £6.90 Read more
Quickset nozzle

The Quick-set Nozzle is designed to be used in Quick-set hot ends, as used in Huxley Duo, Mendel 3, the Dual Colour Upgrade kits and Ormerod 2 kits shipped from June 2015. The nozzle is made from stainless steel and there … Read More

not rated £7.15 Select options