Heatsink block
Aluminium heatsink block for RepRapPro hot end. Suitable for use with Ormerod, Huxley and Mendel kits. Please note – this part is not suitable for use with the Quick-set hot end.
Hobbed insert
Stainless steel hobbed insert, drives the filament into the hot end of your 3D printer. Also fit RepRapPro extruder drives.
M3x8mm spacer
Plated brass cylindrical spacers, as used for bed probing on the Fisher Delta 3D printer. Diameter: 4.75mm Length: 8mm Thread: M3x0.5mm
Meanwell 12v PSU
As used on the RepRapPro Ormerod 2 3D printer. This power supply features auto input voltage switching for AC 110v or 240v operation, and is extremely robust. It will happily power a 200x200mm (8″x8″) heated bed, as well as NEMA17 … Read More
MXL drive belt
Black rubber, fibreglass reinforced, 1/4 ” (6.25mm) wide MXL drive belt. Works with MXL pulleys. Priced per metre.
MXL Pulley
Aluminium drive pulley. 18 teeth. MXL tooth profile, 2.032mm pitch, to fit MXL belt which you can get from here. The pulleys are supplied with an M3 grub screw.
NEMA17 stepper motor
NEMA 17 stepper motor, fits Fisher 3D printer. Also suitable for Ormerod and Mendel sized 3D printers and geared extruder drives. Frame size: 42mm Length: 34mm Shaft diameter: 5mm
One piece nozzle
One piece stainless steel nozzle to fit RepRapPro Ormerod, Huxley or Mendel hot end. The nozzle comes with a short length of PTFE liner. This is pre-fitted before shipping. Please select 0.3mm or 0.5mm nozzle size from the drop down.
Proximity sensor
The modulated proximity sensor and loom consists of an infra-red emitter and detector and the four wire loom to connect it to the controller PCB. The proximity sensor is attached to the X carriage and it works by bouncing infra-red light off … Read More
PTFE bowden tube
PTFE bowden tube 4mm OD x 450mm length for use with RepRapPro 3D printers. This is the tube which leads from the extruder drive to the hot end along which the filament is fed.
Quick-set cooling block
Aluminium heatsink cooling block for use in a RepRapPro Quick-set hot end. Suitable for use with Huxley Duo, Mendel 3, the Dual Colour Upgrade kits kits and Ormerod 2 kits. Nozzle changes with the Quick-set cooling block are easy – simply … Read More